Hi All,

Here is a Hasbro BS 6" Han/Tuantaun I customized.

Tauntaun - I glued and filled in the joints and then I covered it with cotton wool and once dry I then made the blanket by cutting out a design on paper and covering that with wool and painted it and then glued it to the tauntaun.

The straps and bridle are cut out of leather and then I attached them and the saddle was cut away from the mold then covered in thin leather and also attached to the figure. I used O-rings for the metal parts of the bridle and stirrups and then cut the plastic from the stirrups and the attached the O-rings and leather.

The large roll was done by cutting out some inner lining from a WW 2 German winter coat then rooled it up and used thin leather for the straps and 1/6th buckles. The two smaller rolls I used some old material rolled them and again used thin leather and the poles for the shelter are just wooden scurers. The transmitter and bino are from the figure and I just repainted them and added leather for the straps.

Han - Had is joints glued and filled in and then I covered the clothing and boots with tissue paper and once dry painted him, The weapon and holster are from the figure and were painted and attached.

The goggles I cut out the plastic and replaced the cut section with some thin plastic, I used the fur lining that came with the 1/6 Hasbro Hoth Han and cut it off and then cut out a thin piece and attached it to the hood and the scarfs are just some old pieces of materials.

Base - The base is high density foam cut to shape and for the snow I used spakfilla/PVA glue and a little water and then spread it over the base. While the snow was drying I attached the figures and then used some of the snow mix and dapped it over the figures to simulate snow.